4030 Pleasantdale Rd Suite A, Doraville, GA 30340

5500 Cove Base Adhesive

Brand: Powerhold

Base Polymer: Acrylic Polymer

Color: Beige

Solids: 54-59%

VOC Content: <5 grams perliter

pH: 9.3

Consistency: Paste

Trowelability: Light, Easy

Storage: 40°-95°F

Application Temperature: 65°-95°F (18°-35°C)

Open Time: Up to 30 minutes

Freeze/Thaw Stability: 5 cycles @ 20°F

Shelf Life: One Year in Unopened Container

Available Stock: 30 Ounce (0.88 L) Cartridges

Get Estimate

Description:

Powerhold 5500 Cove Base Adhesive is a premium solvent-free adhesive with fast, aggressive wet suction to grip rubber and vinyl wall base. Powerhold 5500 can be used over most interior wall surfaces with the exception of vinyl wall covering and other similar non-porous surfaces that prevent the curing of any latex-based adhesive. While the adhesive is designed to meet the challenges of poorly ventilated areas, sufficient air exchanges are still required to ensure proper curing of any latex-based adhesive.

Recommended Substrates:

• Porous Concrete

• Properly Prepared Gypsum

• APA Approved Plywood

• Drywall

• Fully Cured Porous Masonry Walls

Limitations:

-For interior installations only.

-Do not install when ambient temperature is not between 60ºF & 95ºF.

-Do not install when ambient relative humidity is above 65%.

-It is the sole responsibility of the installer to determine the suitability and compatibility of the adhesive for the user’s intended use.

Instructions:

Adhesive, wall base and job site must be conditioned at 65°F - 80°F for 48 hours before and after installation.
Use only on structurally sound surfaces, dry wall, concrete block, brick, plywood, paneling, masonry, plaster, etc.
Apply to surfaces that are clean, dry, and free from dust, wax and grease. Remove loose paint, plaster, old adhesive and other contaminates that would interfere with adhesion.
Cement or plaster must be thoroughly seasoned and dry.
With a 1/8" square or V-notched spreader, or proper width applicator nozzle, apply adhesive to the back of base or wall surface.
Press base firmly into place immediately after application of adhesive.
Roll base immediately after placement to the wall with a base roller to achieve adhesive transfer and the optimum bond.
For best results, it is recommended to wipe the back of rubber wall base with Mineral Spirits to remove residual mold release from manufacture. DO NOT APPLY OVER NON-POROU

Clean-up

Remove wet adhesive immediately with a damp cloth. Dried adhesive residue will not be removed without damage to the substrate or wall base.

Disclaimer: The specifications provided on this page are based on the manufacturer's technical documents. For the most accurate and up-to-date information, please refer to the original technical documents provided by the manufacturer. Click here to view the technical document.