4030 Pleasantdale Rd Suite A, Doraville, GA 30340

7200 Wall Base Adhesive

Brand: ROBERTS

Product Type: Acrylic Polymer Paste

Color: Creamy Tan

Odor: Mild, sweet odor; odorless when dry

Open Time: Up to 10 minutes

Working Time: Up to 30 minutes VOC: < 1 g/L

Shelf Life: 1 year in unopened container

Storage: Protect from freezing

Available Stock: 30 oz. Cartridge

Get Estimate

Description:

ROBERTS 7200 Wall Base Adhesive is a superior grade, solvent free and zero Volatile Organic Compound (VOC) product with excellent holding power and great wet suction. The acrylic base formula of this adhesive is non-staining for easy cleanup, features a strong initial grab for fast installation and is odorless when dry. This adhesive has anti-microbial protection to prevent growth of bacteria and mold. It meets the strict requirements of the South Coast Air Quality Management District and may contribute one LEED point as a low emitting adhesive.

Features & Benefits:

Excellent holding power and great wet suction
Fast set-up and non-staining formula
Strong initial grab for holding wall base
Outstanding plasticizer migration resistance
Enviro-Friendly – solvent-free and LEED® compliant; VOC < 1 g/L, SCAQMD Rule 1168
CRI Green Label Plus® Certified – GLP #71129
GoldGuard® antimicrobial product protection

Limitations:

-ROBERTS 7200 BASE BOND is not recommended over a non-porous surface such as painted substrates or metal.

-For interior installations only.

-Concrete and plaster must be properly seasoned and dry prior to installation.

-Ensure adequate ventilation during wall base installation.

Instructions:

Preparation:

30 oz. Cartridge – Unscrew cap, cut top seal and replace ROBERTS® 10-981-25 SNOZZLE.
Surface must be clean, dry and free of contaminants including paint. A bond test should be performed (at least 48 hours prior to the scheduled installation) to ensure the surface is suitable. There should be some difficulty in removing the wall base from the surface, but not all situations will result in destruction of surfaces. If the back of the wall base is soiled prior to installation, clean with a cloth dampened with a mild soap and water solution, rinse and dry.

Installation:

Maintain a consistent and relative ambient humidity before, during and after installation (between 65-85° F with a maximum RH od 65%). Apply adhesive to the back of the wall base with either a 1/8” saw-tooth trowel or the cartridge nozzle to ensure 90% coverage of adhesive while not spreading within ¼” from the top if the wall base. Observe the appropriate open time. While the adhesive is still fresh, press the wall base firmly in place. Be careful not to stretch the wall base during the application process. Use hand roller to ensure a secure and void-free bond between the wall base and the substrate. Roll the wall base in the direction of the last piece installed. This will secure a tight fit at the seams. Observe 24-48 hours after installation to allow the adhesive to properly cure. Open Time: Up to 10 minutes. Working Time: Up to 30 minutes.

Curing:

Up to 24-48 hours. High temperature and low humidity will cause the adhesive to cure faster.

Clean-up

Fresh adhesive – warm, soapy water. Dried adhesive – mineral spirits (sparingly) on a clean, cotton cloth. Do Not pour cleaning agent directly onto wall base

Disclaimer: The specifications provided on this page are based on the manufacturer's technical documents. For the most accurate and up-to-date information, please refer to the original technical documents provided by the manufacturer. Click here to view the technical document.