4030 Pleasantdale Rd Suite A, Doraville, GA 30340

5100 Tread Nose Compound Adhesive

Brand: Roppe

Color: One Part Cream, One Part Off-White; Dark Greenish Beige when Mixed & Cured

Approved Products for Use: Rubber & Vinyl Stair Treads

Description:

5100 Tread Nose Compound Adhesive is a solvent free, non-flammable, high performance Epoxy Caulking Compound used for indoor installations of Rubber and Vinyl Stair Treads. This epoxy caulking compound provides support to the “nose” area, particularly on stairs that have irregular wear or oddly shaped leading edges.

Trowel Size

No Trowel Needed, Applied with Cartridge applicator or putty knife to the inside radius of tread noses.

Approved Substrates:

Properly prepared interior porous and non-porous on grade, below grade and above grade Concrete, Terrazzo, Ceramic Tile, Metal, well adhered Epoxy, Wood and Cement-based self-leveling underlayments and patching compounds

Adhesive Working Temperatures:

Area and material should be maintained between 65°F (19°C) and 85°F(30°C) for at least 48 hours before installation, during installation, and thereafter.

Adhesive Working Time:

Flash Time*: Immediate Installation

Working Time**: 30 Minutes

Mixing Procedures

Quart Units: Add all of Part B into Part A. By Hand, mix using the furnished paddle with a rotary motion while lifting from the bottom. By Drill, less than 300 RPM, mix using mixing paddle. Mix until no streaking and then an additional three (3) minutes. Higher mixing speeds and/or longer mixing time will reduce the open time/working time and can cause premature curing of the adhesive. Adhesive will not cure if not properly mixed. Immediately remove mixed material from the container.

13 ½ Ounce Dual Cartridges: Material is self-mixed when pumped through cartridge tip furnished. When applying, the first six (6) inches of unmixed material from each nozzle must be discarded to prevent bond failure and oozing of unmixed material down the face of the riser! It is recommended to transfer nozzle to each new cartridge to prevent discarding material from each new cartridge.

Moisture and PH Requirements

ASTM F 1869; Calcium Chloride, 5 lbs

ASTM F 2170; Relative Humidity, 80%

pH; 7-10

Clean-up

Remove any adhesive from surface of materials with a soft clean cloth with warm soapy water or denatured alcohol, while the adhesive is still wet. If adhesive has dried, gently remove the adhesive from the surface and clean the surface with a soft clean cloth with denatured alcohol or mineral spirits and then rinse well with warm soapy water and clean cloth, area may discolor.

Limitations

-Light Foot Traffic, 24 Hours after Installation (Immediate with use of 4100 Quik Stik Tread Tape Adhesive)

-Commercial Foot Traffic, 48 Hours after Installation

-Maintenance, 72 Hours after Installation

-Not for use outdoors

-Not for use over existing floor covering or old adhesives

Shelf Life

Shelf life is one year when stored between 65° F (18° C) and 90°F (32° C) in original unopened container

Disclaimer: The specifications provided on this page are based on the manufacturer's technical documents. For the most accurate and up-to-date information, please refer to the original technical documents provided by the manufacturer. Click here to view the technical document.